Dacor CM24P-1 Průvodce řešením problémů stáhnout pdf (Strana 6)

Dacor Technical Assistance: 800-353-2267

Oven Temperature Calibration Instructions:

Classic Wall Oven & Range Temperature Calibration Procedure

Wall Oven Models: CPS/CPD, CPTS/CPTD, ECPS/ECPD, ECS/ECD, PCS/PCD, MCS/MCD Single & Double

Ovens, 27, 30 & 36 inches wide.

Range Models: ERSD30/36/48, PGR30, RSE30, RSG30, RSD30, ERD30/36/48/60, ERDE36/48, MRE30,

MRES30, EGR30, ERG30/36

Classic Products – All models WITH Bake Keypad:

• Select a Bake Cycle, Increase Temperature to 500˚F.

• Quickly press and Hold Bake Keypad until display changes.

• Use Temp Up/Down keypad to select amount of Calibration up to +/-35˚F.

• Press Cancel to lock in new setting. Factory setting is “00”.

Classic Range Model: ERD48 WITHOUT Bake Keypad:

• Turn Power Off to unit.

• Press and hold Cancel Key for the small oven.

• Turn power back on while holding Cancel Key. Two Orange “00” will display.

• Quickly press Cancel Key again. “00” will appear on the large oven display.

• Use Temp Up/Down keypad on large oven to select amount of Calibration up to +/-35˚F.

• Press Cancel to lock in new setting. Factory setting is “00”.

Classic Range Model: ERD36 WITHOUT Bake Keypad:

• Turn Power Off to unit.

• Press and hold Cancel Key.

• Turn power back on while holding Cancel Key. Two Orange “00” will display.

• Use Temp Up/Down keypad on large oven to select amount of Calibration up to +/-35˚F.

•

Press Cancel to lock in new setting. Factory setting is “00”.

Discovery Wall Oven Temperature Calibration Procedure

Wall Oven Models: EO130, EO230, EO127, EO227, PO130, PO230, PO127, PO227, MOV130, MOV230,

MOV127, MOV227, MOH130, MOH230, MOH127, MOH227

• Press and HOLD “#” keypad, Press and HOLD Cancel/Secure keypad.

• Hold both buttons for 5 seconds.

• Once the display changes, let go of the Cancel/Secure keypad first then the “#” Keypad. Enter your

Dacor Servicer Identification Number (or: S1236) and press Enter.

• For Double ovens (single oven skip this step), select the oven that is to be Calibrated (Upper or Lower).

• Press the Service Temp keypad then the OK keypad to acknowledge the Calibration Warning.

• Using the Number Keypad, select the corresponding number next to the Cycle you wish to Calibrate.

• Once the desired Cycle is Highlighted, Press the +5˚F or -5˚F to select the amount of Calibration.

• Once the desired Calibration is displayed, press the OK keypad to lock in new setting.

• Press the Cancel/Secure keypad to EXIT the Temperature Calibration Mode.

PG: 6

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Žádné komentáře

Dacor CM24P-1 Průvodce řešením problémů Strana 6